Replacing the hands on a Borealis Sea Diver?

MrThompsonR

Master WIS
Has anyone done this? If so, can you post the hole sizes needed? Not sure these will fit?

A couple pics of the hands I'd like to add…

These are from a Tudor/ Rolex Submariner

Screen Shot 2014-08-21 at 6.03.20 AM.jpg

Screen Shot 2014-08-21 at 6.04.19 AM.jpg
 

Borealis Watch Admin

Administrator
Staff member
The Sea Diver uses a Miyota 8215 movement so you have to make sure hands you're planning to replace with are for a Miyota 8215. Also make sure hands do fit in terms of dial dimensions.
 

Andy A

Master Apprentice WIS
Occasionally the stem may need to be cut on the seconds, they can be too long depending where you got the hands from.
 
it can be done. you have a bunch of aftermarket parts for Miyota 82xx series. personally , I would go for plongeur hands, with orange minutes hand.
 

Borealis Watch Admin

Administrator
Staff member
The text says it is for Miyota 8215 series so should do the job (taking into account detail on dial size, seconds hand stem, ...)
 

nicholas stockman

Master Apprentice WIS
Is there anybody here who can suggest a place to get a set of hands like the Seafarer but for my Sea Diver w/BGW9 lume a well? and Thanks for info in advance!
 
I would not use gold tone, I do not think you would like the contrast or too much of it. I would change with like type merc hands,
 

olly74

Master Apprentice WIS
I think plongeur hands in stainless steel or with orange Minute hand will look nice for the Sea Diver...
 
Top